AES 7170 Uživatelský manuál stáhnout pdf (Strana 28)

40-7705I-UM Page 28 Rev 4 March 16, 2007

In the xterm terminal window, enter the following command to initiate the script

to modify the configuration of Ethernet port 1 (eth0).

./editnetworketh0<Enter>

Don’t forget to first type the dot and forward slash “./”. The following window

for the KWrite text editor with the configuration file for Port 1 should appear.

Use caution as incorrect settings could disable the system, especially if it were

already configured.

Figure 5-5 KWrite Text Editor with file ifcfg-eth0 Open

There are usually about 6 lines of parameters in the

configuration file. Only edit the lines described below to

provide the parameters needed for your installation. Do not

edit the parameter name or add spaces. You only need to edit

or confirm the following lines: (order not important)

ONBOOT=yes

IPADDR={IP address for this MultiNet Receivers port}

NETMASK={Net mask for the attached network}

GATEWAY={Gateway for the attached network}

Once you have modified the lines to your desired

settings, select “Quit” in the File menu. If the editor

detects that you made changes, you will be asked to

save the current Document. Click [Yes]. Click [No]

if you are unsure of your edits and want to begin

again.

Once the editor is closed the script will continue by initializing the new settings

and running a few tests. Watch the screen for errors.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 110 111

Žádné komentáře

AES 7170 Uživatelský manuál Strana 28