AES 7170 Uživatelský manuál stáhnout pdf (Strana 25)

40-7705I-UM Page 25 Rev 4 March 16, 2007

5.12 Review your TCP/IP Configuration:

The TCP/IP parameters of all TCP/IP devices must be properly configured in

order for the MultiNet Receiver to communicate with any local or remote IP-Link

Transceiver(s), and any other TCP/IP devices it needs to communicate with.

As stated before, if you are connected as shown in Figure 4-1 using the 7170 that

was shipped with your receiver, then no configuration is needed for the pair to be

operational.

There are two Ethernet adapters incorporated into the MultiNet Receiver. One is

identified as eth0 the other as eth1. You can issue the Linux command ifconfig

at a command prompt to review the TCP/IP settings. It is best to request IP

information one adapter at a time. Enter the following to view Port 1 settings:

ifconfig eth0<Enter>

Review the data on the screen. Then, to review the settings of Port 2, the second

adapter, enter the following:

ifconfig eth1<Enter>

You can scroll the screen display to view information that has scrolled off by

using the <Pg Up> and <Pg Dn> keys.

5.13 Factory Default TCP/IP Settings

The table below shows the factory default settings of all TCP/IP devices in a

MultiNet Receiver / 7170 IP-Link transceiver pair. Both Receivers and IP-Link

Transceivers in a dual system are configured the same from the factory. You

MUST modify the TCP/IP settings of the second Receiver and IP-Link

Transceiver before the two can be connected together in the same network. If the

new MultiNet system is being placed in a network that has existing MultiNet

devices then these new devices need unique settings.

Failure to do so will result in conflicts.

7705i Default Ethernet Port Settings

Parameter Ethernet Port 1 / eth0 Ethernet Port 2 / eth1

ONBOOT Yes Yes

BOOTPROTO STATIC STATIC

IPADDR 192.168.0.101 10.0.1.221

NETMASK 255.255.255.0 255.255.255.0

GATEWAY 192.168.0.1 10.0.1.7

7170 IP-Link Transceiver Default Ethernet Port Settings

IP Address 192.168.0.11

GATEWAY 192.168.0.1

NETMASK 255.255.255.0

Table 5-4 Factory default TCP/IP settings

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 110 111

Žádné komentáře

AES 7170 Uživatelský manuál Strana 25