AES 7170 Uživatelský manuál stáhnout pdf (Strana 110)

40-7705I-UM Page 110 Rev 4 March 16, 2007

All other Contact ID Event Codes will be reported as:

Y XXX where XXX is a copy of the event code. OR

SY XXX when PXXX is the event and where XXX is the Point ID or Contact ID number

Note: AES recommends not using Radionics 6500 emulation, when using IntelliTap to report Contact ID. If at all possible use

Ademco 685 emulation if you have a monitoring system that can support it.

( Line card #4 next page)

Line Card # 4 4+2 received from IntelliTap. Events are translated.

Signal format: 1RRLssssssACCTsAssCC<0x14>

A = Character A for alarm event.

CC = two digit zone code.

See “Line card #1”, “Signal format” in “Mode 1 – Radionics 6500 compatible output” for explanation of other signal

format codes.

Event plus Zone, Status and Fault Codes, AES Subscribers with IntelliTap.

All 4+2 messages will be reported as follows:

AssCC where CC is a direct copy of the received 4+2 report code.

Input Signals:

In mode 1 the AES receiver will respond to two inputs or signals from the monitoring system.

<0x06> receiver considers last message acknowledged

<0x15> receiver will re-send last message (if not acknowledged)

Other Messages:

301ssAESs7000sVX.XXs<0x14>

X.XX this reports the version number of the firmware

1 2 ... 105 106 107 108 109 110 111

Žádné komentáře

AES 7170 Uživatelský manuál Strana 110