AES 7170 Uživatelský manuál stáhnout pdf (Strana 103)

40-7705I-UM Page 103 Rev 4 March 16, 2007

Example Message Strings Description of Event Produced by an AES Subscribers

R1 ACCT 18 E602 00 C000 Automatic Supervisory Check-In. Zone/contact ID = 000

R1 ACCT 18 E140 00 C0nn Alarm Signal or input went active. Zone/contact ID = Zone Number

R1 ACCT 18 P140 00 C0nn Prior Alarm. Input still active. Zone/contact ID = Zone Number

Reported during Status or Automatic Supervisory Check-In

R1 ACCT 18 R140 00 C0nn Alarm Restoral or input to normal. Zone/contact ID = Zone Number

R1 ACCT 18 E305 00 C901 Watchdog, or Push-button Reset. Zone/contact ID = 901

R1 ACCT 18 E305 00 C902 Power-On Reset. Zone/contact ID = 902

R1 ACCT 18 E307 00 C8nn Diagnostic Fault. Zone/contact ID = Fault Code. See Fault code list on a following page.

R1 ACCT 18 R307 00 C800 No Faults, Unit OK or Restoral of all Prior Faults. Zone/contact ID = 800

R1 ACCT 18 P307 00 C8nn Prior Diagnostic Fault still active. Reported during Check-In.

Zone/contact ID = Fault Code. See Fault code list on a following page.

R1 ACCT 18 E351 00 C905 IntelliTap phone line cut. Zone/contact ID = 905

R1 ACCT 18 R351 00 C905 Restoral of IntelliTap phone line cut. Zone/contact ID = 905

R1 ACCT 18 E354 00 C906 Exception – Unit or Subscriber Failed to Check-In. Zone/contact ID = 906

Generated by MultiNet Receiver on failure to receive test message within specified time frame.

R1 ACCT 18 E354 00 C915 Exception – Unit or Subscriber NetCon is 6 or 7. Zone/contact ID = 915

Generated by MultiNet Receiver on failure to receive test message within specified time frame.

R1 ACCT 18 R354 00 C906 Exception Restoral – Unit or Subscriber on Line. Zone/contact ID = 906

R1 ACCT 18 R354 00 C915 Exception Restoral – Unit or Subscriber NetCon is 5 or lower. Zone/contact ID = 915

R1 ACCT 18 E356 00 C903 Acknowledge Delay or Communication time-out. Zone/contact ID = 903

R1 ACCT 18 E370 00 C0nn Zone Trouble. Zone/contact ID = Zone Number

R1 ACCT 18 P370 00 C0nn Zone Trouble still active. Zone/contact ID = Zone Number

Reported during Status Request or Automatic Supervisory Check-In

R1 ACCT 18 R370 00 C0nn Zone Trouble Restoral. Zone/contact ID = Zone Number

Note that this is a restore signal and may not cause an alert. Look in log files.

REC# = MultiNet Receiver ID IPL# = IP-Link ID ACCT = Subscriber ID

n or nn = variable number, ran

as s

ecified

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 109 110 111

Žádné komentáře

AES 7170 Uživatelský manuál Strana 103