AES 7170 Uživatelský manuál stáhnout pdf (Strana 20)

40-7705I-UM Page 20 Rev 4 March 16, 2007

5.3 Power Down - Information:

The power to the 7705i should not just be removed without going through the

proper shut down procedure.

DO NOT REMOVE POWER OR TURN OFF POWER of the 7705i

MultiNet Receiver WITHOUT USING THE PROPER SHUT DOWN

PROCEDURE!

This receiver is a Linux server and improper shut down could damage files and

prevent operation. There are several ways to shut down a Linux server. Linux

provides a command named “shutdown ” to perform this function.

● To shut down a MultiNet receiver, enter the following command from a

command line prompt:

shutdown –h now<Enter> Or

● To shut down a MultiNet receiver from the GUI, right click on the desktop and

select “Shutdown Server!”

5.4 Local Access and Login: - Initial Setup

Local access means to operate the MultiNet Receiver using a keyboard, monitor

and mouse that are connected directly to the back of the Receiver. Login is

required to operate the Receiver in this manner.

After a successful power-up, you should be presented with the login prompt “aes

typically the last lines seen before the login prompt on the display for a normal

boot up. Press <Enter> after these lines are displayed if the “aes login” is not

displayed. For Super user Administrator functions you need to login as root

using the current password. The factory default password for user root is

peabody2.

• At the “aes login” prompt, type

root<Enter> then

peabody2<Enter>.

Note: After initial setup, if the password has been changed, as it should be,

use the current password for user root to login to perform setup and

configuration functions.

○ Be sure to log out when finished. See “User Logout

”

○ The user root is the most powerful Super user in a Linux server.

Do not leave the system unattended when logged in as root!

○ User root should only be used to perform administrative functions!

○ To prevent unauthorized access – change default passwords as

described in “Managing Users

”, section 9.

When the startup and login process is complete, you should be presented with the

command prompt “[root@aes root]#”. See Figure 5-1 below. Enter key may need

to be pressed before the prompt is actually displayed.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 110 111

Žádné komentáře

AES 7170 Uživatelský manuál Strana 20