AES 7170 Uživatelský manuál stáhnout pdf (Strana 13)

40-7705I-UM Page 13 Rev 4 March 16, 2007

3.2.3 Single Board Computer Connector Section: Contains connectors for computer

peripherals.

• Serial Port 1 / (COM 1) Upper: [/dev/ttyS1] Typically used to connect to

alarm monitoring system for signals communicated via RS-232.

See Appendix E for a list of Alarm messages generated.

• Serial Port 2 /(COM 2) Lower: Unavailable. Not Used.

• Monitor, CRT (J8): Plug the video monitor into this Jack. ¿

• Ethernet Port 1 (J10) [eth0]: Can be used for a dedicated crossover

Ethernet cable connection to a 7170 IP-Link transceiver using no

additional network hardware or as a connection to an Ethernet Hub/Switch

using a standard straight through Ethernet cable.

Pre-configured factory default to static IP address 192.168.0.101.

• Ethernet Port 2 (J11) [eth1]: This Port is not used.

• USB ports 0 & 1 (0 is Lower): Not Used

• PS/2 Keyboard/Mouse port (J16): ¿ Use supplied Y-cable to connect a

PS/2 keyboard and a mouse. These devices are used during configuration.

Once configured access to the MultiNet Receiver is done through a

network workstation.

• Reset Switch: Press and hold for 2 seconds to perform a hard reset. Do

this only in the event of a lockup condition when proper shut down

procedure cannot be accomplished.

3.2.4 Printer Port Section: Contains a single printer connector:

• Printer Port: Plug the Db-25 male end of the printer cable connected to a

supported parallel printer. Attach only a printer Listed by UL for

“Signaling use” under UL 864, such as an AES 75-0101.

See Appendix F for a listing of generated messages.

Note: ¿ These are to be used for initial setup only and are not to remain

connected.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 110 111

Žádné komentáře

AES 7170 Uživatelský manuál Strana 13